Shop by Category
Shop by Brand
- Aaeon
- Accel Instruments
- Adlink
- Antaira
- Arbor
- Array
- Asian Electron
- Atek
- Atten
- Bravo Communications
- Diamond Systems
- Digilent -MCC
- Digi International
- Dino-Lite
- Dwyer
- Extech
- GW Instek
- Handywave
- ICS Electronics
- ITECH
- LabJack
- Jewell Instruments
- Juniper
- Lascar
- Micronor Sensors
- Motrona
- MSR
- Numato
- Omega
- Opto22
- ORing
- PowerVar
- Rigol
- Senonics
- Siglent
- Tripp Lite
- TVBTECH
- Twintex
- Vaisala
- Winmate
ITECH IT6874A 150V/1.2A/180W 60V/2A/120W DC Power Supply
$0.00
IT6300 series is high-performance programmable triple channels DC power supply, each output voltage and current can be set from 0 to maximum rated output. This series provides series connection, parallel connection and synchronous functions of channel， which offer multi-purpose solutions for customers test.IT6300 series is with high resolution 1mV / 1mA and remote sense function, which make the test more accurate. With built-in standard USB / RS232 / GPIB communication interface, IT6300 series greatly enhance the communication speed, and customers also can adjust the digital step value by using the cursor to to facilitate the operation.
Features
♦ Triple output voltage, all are adjustable.
♦ Optional serial/ parallel/ track mode *1
♦ The voltage and current for each channel can be displayed at the same time
♦ Small size of 1/2 2U
♦ VFD display
♦ Function keys with LED light
♦ Adjust the digital step value via cursor
♦ Output switch control
♦ High accuracy, high resolution and high stability
♦ Remote measurement function, compensation online pressure drop *2
♦ Comprehensive protection function
♦ Intelligent fan control, reduce noise
♦ Built-in RS232/USB/GPIB communication interface for part of the models
*1: Table 1 for details *2: IT6300A/B
Track mode
CH1 and CH2, CH2 and CH3, or all three channels to be set as track mode, if any one channel parameter changed, the corresponding parameters of the other channels will also change in direct proportion.
For example, set up voltage and current of CH1 and CH2 to be CH1:4V, 1A; CH2:8V, 2A. Set CH1 and CH2 in track mode, in output off and Meter state, VFD is shown below:
-
Track mode
CH1 and CH2, CH2 and CH3, or all three channels to be set as track mode, if any one channel parameter changed, the corresponding parameters of the other channels will also change in direct proportion.
For example, set up voltage and current of CH1 and CH2 to be CH1:4V, 1A; CH2:8V, 2A. Set CH1 and CH2 in track mode, in output off and Meter state, VFD is shown below:
Datasheet
http://www.itech.sh/Upload/File/20171023145720.pdf
