Shop by Category
Shop by Brand
- Aaeon
- Accel Instruments
- Adlink
- Antaira
- Arbor
- Array
- Asian Electron
- Atek
- Atten
- Bravo Communications
- Diamond Systems
- Digilent -MCC
- Digi International
- Dino-Lite
- Dwyer
- Extech
- GW Instek
- Handywave
- ICS Electronics
- ITECH
- LabJack
- Jewell Instruments
- Juniper
- Lascar
- Micronor Sensors
- Motrona
- MSR
- Numato
- Omega
- Opto22
- ORing
- PowerVar
- Rigol
- Senonics
- Siglent
- Tripp Lite
- TVBTECH
- Twintex
- Vaisala
- Winmate
Bravo Communications LAN/Network Surge-Protected Patch Panels - RM16RJ45/LAN8G
$0.00
Product Tags:
Product Tags:
RM16RJ45/LAN8G
RJ45
Gigabit Ethernet CAT.6 LAN Protector (8 Wires)
(16-PORTS ACROSS / 1U SPACE)
- Protects all Cat.5/Cat.6 ethernet ports up through full duplex ethernet
- Meets Gigabit ethernet 1000Base-T standard IEEE 802.3AB and Legacy ethernet UTP standards
- Protects all 8 signals/wires per port up to 250 Mhz with straight through wiring
- Supports 1 gigabit ethernet applications (and up to 2 Gigabit data speeds)
- 16-ports across with single-point grounding using only 1U of 19.0” vertical rack space. May be front panel screw grounded or grounded using bravo supplied 9.0” long 12 AWG ground wire
- Individual LAN port surge test light for all ports (diamond-shaped red LED)
- Normally rear panel surge protected but can also be front panel surge protected
- 4-Port card modules are hot swappable
- Stops all voltage transients greater than ± 8.2 Volts and up to 25k Amps per line in less than a Pico-second.
- Protects LAN equipment repeatedly and then automatically resets itself
- Unique 3-stage protection on all signal lines is powerful enough to use for both inter-building and intra-building cable run installations.
- Compatible with both half and full Duplex ethernet equipment installations for universality
- Shielded (STP) connector version is also available (SRM16RJ45/LAN8G)
- 5-year limited warranty